|
HowFullAmI Tank
Gauges THAT WORK! |
|
The
Gauge |
|
Sender
Unit |
|
Typical Installation |
|
The HowFullAmI tank gauges are a product of the
Electric Houseboat. While the design process was taking place for the
Electric houseboat we discovered that tank gauges were very unreliable. The gauge is a bar graph with ten green LED’s that indicates the liquid level to 10%
resolution. There is a yellow warning LED that indicates that a waste tank is
up to 60% full or a water tank is down to 40% full. Then there are flashing
yellow and red LED’s indicating that a waste tank is up to 80% full or a
water tank is down to 20% full. A new patented technology was designed into the
HowFullAmI system. There are no moving parts or devices in contact with the
liquid. There’s no stick on tape, straps or devices inserted
in the tank. These units may need adjusted to the height of your tank but
will not need to be recalibrated in the future. The
HowFullAmI tank gauge system is not magic but uses the age old physics
of weighing the water. This is accomplished by measuring the pressure at the
bottom of the tank from outside the tank and above the liquid (U.S. Patent 6666085B1). Some of these gauges have been in service for over
two years without a known failure and we don’t expect to see failures. All the KYS Monticello River Yachts since 2003 and have been
equipped with the HowFullAmI gauges. The gauges mount in a standard 2 inch hole and use a
small three wire cable to connect them to the sender unit. Installation is outside the tank and made with
standard PVC pipe fittings allowing for easy retrofit to replace failed
systems or no systems. Sender Unit
$179.00 Gauge $68.00
Plus Shipping |
